Silence a Noisy Garage Door

local garage door repair, garador, how to adjust garage door

Noisy garage doors are usually caused by worn rollers, loose hardware, parts that need lubrication or an opener in need of anti-vibration pads—all simple fixes.The fixes for a garage door that makes a racket when it opens and closes are fairly easy and will take less than an hour. We Start by tightening all the door and track hardware. We Use a deep socket and a ratchet on all the nuts to snug them up. But we don’t overtighten—that can pull the carriage bolt heads right through the door skin or strip the lag screw holes.

Next, we check for worn rollers and hinges. Many track rollers have unsealed bearings that self-destruct after years of rolling around in a dirty environment. The wear can be so severe that the rollers actually wobble as the door operates. If your rollers are worn, we aill advice you to consider replacing them with nylon rollers with sealed bearings. Nylon rollers are quieter and don’t require periodic oiling. But they are more expensive than steel.

Worn hinges are less common than worn rollers. But sloppy hinges make a lot of noise and can cause the door to bind and wear out the tongue-and-groove joints at the door sections. Some play at the hinge is normal. But if we see an oblong hole where the tubular hinge pin mates with the hinge bracket, we will replace the hinge. Gray dust and metal filings around the hinge pin are early signs of wear.

Once we’ve replaced the worn door components, we check the garage door opener chain. A loose garage door opener chain makes loud slapping sounds and causes jerky door movements that smack the rollers against the track. So we start by tightening the chain. If you have a track drive opener, the next step is to lubricate the opener track with grease. If you have a screw drive opener, we grease the threads

Next, we spray the hinges, roller bearings (unsealed style), and springs with a garage door lube like the Prime Flo garage door lubrication kit. Also we hit the torsion bar bearings, and any other pivot points. The special garage door lube penetrates the parts as a liquid and dries to form a non-tacky grease that won’t attract dirt and dust, which can gum things up. Lubricate all moving parts every six months to reduce wear and keep the door quiet. Avoid other lubricants such as oil, grease, or spray lithium grease. They’re cheaper, but they don’t penetrate as well and tend to pick up dust and grit—just what you don’t want on moving parts.

Written by